| KAVAN Electronic Devices are designed and built by a German engineer living in the United States. They can add enjoyment, safety or economy to your Radio Control hobby. Each device is either in a plastic case or can be protected with enclosed plastic heat shrink tubing. Some of the devices require simple soldering such as the installation of a servo wire with connector to the printer circuit board. German and English instruction. |
Onboard Glow Plug Driver
| The Onboard Glow Plug Driver replaces your (1.2 v - 1.5 v) starting battery and minimizes engine failures from fuel hitting the "cool" glow plug element at low throttle settings. Install between the receiver and throttle servo. Adjust the On-Off point to give power to the glow plug at the throttle setting you desire. Power enough to drive two glow plugs but requires an additional No. 0274C glow plug connector. Built-in servo reverse. |
| Requires: servo wire with connector, servo wire with mating connector, a 1.2 -1.5 v battery and holder. |